RV Roof Vent Cover
Camco RV Roof Vent Cover is designed to allow fresh air ventilation and light into your RV, rain or shine. RVs can get pretty stuffy when they’re all closed up, but having a constant flow of fresh air through the cabin will help keep the RV feeling and smelling fresh. The aerodynamic cover offers high flow ventilation with a design that allows you to keep it open when it’s raining, or even when you’re traveling. It is easily installed with included mounting hardware by mounting to the existing 14 inch x 14 inch roof vent. Vent cover made of rugged UV stabilized resin with removable louvers for easier cleaning. Available in five different colors.
How it Works
The Camco Roof Vent Cover installs over your RV Roof Vent, allowing you to open your roof vent during rain or shine and without impeding air flow. The removable louvers allow you easy access to your roof vent for maintenance and cleaning. For installation you will need a pencil, a drill with a 3/16 inch bit, a Phillips head screw driver and a crescent wrench. The rest of the materials are included with the product. To install the Vent Cover, first center it over your roof vent with the louvers facing the rear of the RV and mark the location of the slots with your pencil. Lay the mounting bracket on the roof so that the slot intersects one of the marked locations that are closest to the corners of the vent frame. Mark the locations of the screw hole in the vent bracket onto the vent frame and drill through the frame using the 3/16 inch diameter drill bit. Place one of the carriage bolts up through the bracket slot and fasten the bracket to the roof vent and frame using a #8 screw, washer, lock washer and nut which are provided for you. The washers and nuts will go on the inside of the vent frame. Install the other three brackets in the same way. Once all four of your brackets are installed, place the vent cover over the four carriage bolts and attached with the ¼ inch washers, lock washers and nuts. Before you tighten it, make sure the square heads of the carriage bolts are seated in the bracket slots to prevent them from turning. Do not over tighten. There will be a gap between the vent and your RVs roof- this is normal and will help prevent condensation. Your RV Roof Vent Cover is now installed and ready for use!